ما توصّل إليه النقاش

• The most common cause is a 12V cable routed to the camera instead of a 24V cable; many Alexa Mini and Amira cables supply 12V via hot-swap connectors, while 24V appears on a different pin of the sled connector.
• The three-pin output on the M2 carries ground on pin 1, 12V on pin 2, and 24V on pin 3.
• Secondary causes include incorrect battery type or undervolage threshold configured in the camera menu, and undersized cable gauge, which some cable manufacturers overlook.
• Adding more batteries in parallel increases runtime but does not raise voltage; the Alexa 35 draws approximately 140 W and requires adequate conductor cross-section to sustain 24V delivery under load.

يعتمد على

• Whether the issue stems from incorrect cable routing, camera settings, or insufficient power capacity depends on systematic testing with a known 24V cable and a multimeter check at the camera input.

المعدات في هذا النقاش

ALEXA 35الكتالوج

المعدات أو القطع نفسها

1. 2026Low mode وقلب الصورة: ما التحقق من الكاميرا قبل اليومOperator practice
2. 2026Mounting the RIA-1 wireless receiver on ARRI Trinity with ALEXA 35FacebookArri Artemis Trinity
3. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest work flow.FacebookSteadicam operators group
4. 2026القضاء على الاهتزاز مع ARRI ALEXA 35 في Steadicam®: خيارات الرفع الصلب للطبقات لتجاوز نظام dovetailFacebookThe Steadicam Group