ما توصّل إليه النقاش

• A Canon 5D alone is too light to properly balance on a Steadicam sled, requiring added counterweight to pull the arm down into level position
• Cast iron weights can be temporarily attached to the sled shaft as a quick solution for balancing
• Custom steel weight bars with threaded holes along their length, weighing around 12 pounds, can be machined and fitted with Manfrotto quick release adapters for permanent balancing solutions
• Diving weights mounted on either side of a camera bracket can achieve proper balance and weighting
• Commercial weight cages with modular weighted plates in various denominations offer flexibility for different camera and lens configurations
• Canon lenses with fly-by-wire focusing mechanisms present significant challenges for focus pulling on Steadicam rigs compared to lenses with hard stops
• Zeiss ZE lenses with hard stops are preferred over Canon zooms because they respond to lens mapping features in Preston follow focus systems
• Canon zooms require visual focus confirmation through HD transmission rather than traditional marking systems because their focus rings have no defined stops

يعتمد على

• Solutions discussed were specific to earlier Steadicam setups in 2010
• Focus pulling difficulties mentioned relate specifically to Canon's electronic focusing system design
• Some solutions were improvised for individual shoots rather than thoroughly tested designs

المعدات في هذا النقاش

HU3

القطع

Follow Focus

المعدات أو القطع نفسها

1. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest work flow.FacebookSteadicam operators group
2. 2026اسحب التركيز و اقسم نفسك أثناء العمل خاصة على العروض الحيةOperator practice
3. 2025LC-1 (Lens Control-1) follow focus system: wired structure, motors, and early operational experience (1990s).FacebookThe Steadicam Group
4. 2024تعديلات على جهاز الكشافة رقم Steadicam لتوسيع نطاق توزيع الطاقة وربطهاGeneral Discussion