2008منتدى Steadi-Newbies
Setting up a monitor and power system for a Flycam 6000 steadicam rig
مضى على هذا 18 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.
ما توصّل إليه النقاش
- Monitor size between 5 and 7 inches diagonal works well for steadicam use.
- Outdoor monitors should have high brightness measured in nits and anti-reflective coating, while pixel count matters less for steadicam work.
- Video connection to the camera typically uses composite video with yellow RCA connectors or BNC connectors.
- A 12-volt power source is required to operate the monitor.
- Used LCD TV monitors from online marketplaces can be adapted for steadicam use if they have audio-video inputs and 12-volt power input.
- Ten AA rechargeable batteries in a battery holder can be assembled as a budget 12-volt power pack and secured with gaff tape to the sled.
- A hood made from plastic, cardboard, or coroplast improves monitor visibility in outdoor conditions.
- The cable routing holes at the top and bottom of the sled post allow for clean cable management during gimbal balancing.
- Placing the monitor lower on the rig and routing thin cables through sled holes improves dynamic balance without obstruction.
- Holding the sled post close to the body with the battery positioned behind the leg reduces back strain compared to holding the rig extended outward.
- Moving the gimbal higher up the sled post closer to the stage bottom reduces visible movement at the lens.
- Extending the bottom rods as far as possible improves pan inertia and smoothness.
يعتمد على
- Budget battery solutions use consumer-grade components and may require custom cable fabrication with electrical tape.
- Budget monitor hoods are DIY constructions and their effectiveness depends on material choice and construction quality.
- The advice applies to the Flycam 6000 and similar budget steadicam models; professional steadicam systems may have different requirements.
- Monitor outdoor performance with budget equipment is limited without proper light-blocking hood construction.
- The sticker on the sled post may need removal with solvents to access the full post for gimbal adjustment.