2014منتدى General Discussion
مطاردة gimbal عديمة الرحمة على مدى steadicam لحركة الكاميرا الموسعة وتحقيق الاستقرار المشترك
مضى على هذا 12 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.
موضع خلافاختلف المشاركون ولم يصلوا إلى خلاصة. اقرأ النتائج على أنها مواقف، لا إجابة.
ما توصّل إليه النقاش
- A three-axis brushless gimbal can be mounted on a steadicam using a custom divided that allows the camera to move from ground level to overhead by rotating 180 degrees around the gimbal.
- The Porta Head 5 gimbal mounted on a steadicam can operate in follow mode where pan control is achieved by turning the steadicam post, allowing intuitive framing while the gimbal maintains stabilization.
- ويمكِّن وضع أساليب المتابعة، مثل نافذة تتبع درجة 0.6 درجة، مقترنة بالمنحينات الهائلة في البرمجيات الـ gimbal، من إجراء حركات مستجيبة وقابلة للتحكم دون أن يتطلب ذلك مشغلاً منفصلاً.
- The Porta Head 5 system works with Red Epic cameras and can be used from inside a vehicle supported by bungee cords or mounted to a jib arm on a camera car for mobile shots.
- The gimbal operator can manage pan independently while the steadicam operator controls tracking movement, allowing single-operator control with coordinated timing between movement and framing.
- The complete gimbal and camera assembly weighs under 8 kilograms with a Blackmagic camera, remaining lightweight enough for steadicam use.
يعتمد على
- Single-operator follow mode for both pan and tilt simultaneously is not possible with all gimbal systems; alexmos-based software allows separate follow mode control for tilt and pan while some competing systems do not.
- The system was tested primarily with Blackmagic Pocket Camera and Red Epic; testing with Scarlet and Epic cameras had not been completed at the time of discussion.
- Operator adaptation is required because pan control through post rotation works differently than traditional camera pan movements.
- The exact weight and feasibility with heavier camera packages like Red Scarlet or Red Epic was not fully verified.