2008منتدى Cameras (Film/Video/HD)
تركيبة كاميرا F23 للأجهزة اليدوية و Steadicam مع تركيبة التسجيل ذات القطعتين
مضى على هذا 18 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.
ما توصّل إليه النقاش
- The F23 can operate in two-piece mode without inherent technical problems when camera and recorder are in the correct operating modes
- يمكن استخدام ما يصل إلى 100 قدم من كابل كواكس قياسي لتسجيل التردد F23 ذي القطعتين
- لا تدعم الطريقة المزدوجة في حالة F23 سوى معدلات إطارية ثابتة تبلغ 23.98، و 24، و 25، و 29.97، و 30، و 50، و 59.97 فراء؛ ويتطلب العمل السريع المتغير عملية ذات قطعة واحدة
- Fiber optic conversion systems like the Telecast Rattler introduce approximately one frame of audio delay and require two transmitter-receiver pairs for dual-link operation
- The F23 power connector is mechanically similar to Genesis but exits the camera body at a different angle (22.5 degrees instead of side-mounted)
- To record over 30 fps in 4:4:4 chroma subsampling on the SRW-1 recorder, the HKSR103 board must be installed; over 30 fps without this board is limited to 4:2:2
- Back-mounted batteries work for handheld two-piece operation; Steadicam sleds can power the F23 via Y-connector cables
يعتمد على
- Reports about F23 versus Genesis power cable compatibility were conflicting in the source community
- Fiber optic systems were cost-prohibitive for this production at around 800 dollars per day
- The HKSR103 board for high frame rate 4:4:4 recording was rare and expensive
- Audio delay from fiber systems requires sound department awareness and potential delay compensation equipment