2010منتدى Arms
Bearing failures in Glidecam V-25 stabilizer arms
مضى على هذا 16 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.
ما توصّل إليه النقاش
- Early production runs of the Glidecam V-25 were prone to bearing failures occurring after only a few uses
- Bearing failures have been reported in different locations along the arm including the lower stage near the elbow and upper stage sections
- Replacement bearings supplied by the manufacturer as part of an upgrade program did not resolve the recurring bearing failure issue for one user
- Later model V-25 and X-45 units produced from January onward have not exhibited bearing problems
- The manufacturer provides replacement bearings as a warranty service
يعتمد على
- The bearing failures reported may be specific to early production batches of the V-25
- Only one user's experience with recurring bearing problems is documented in detail
- It is unclear whether the failures were caused by defective components, assembly issues, or operating conditions
- The upgrade program mentioned was implemented at an unknown date relative to when the affected unit was manufactured