SteadiHub
2019منتدى Sled

شاحنات سينما القديمة تخسر توازناً بعد غسيل الأكتاف أو الاتصال بالكتاف خلال فترة التوقف البطيئة

موضع خلافاختلف المشاركون ولم يصلوا إلى خلاصة. اقرأ النتائج على أنها مواقف، لا إجابة.

ما توصّل إليه النقاش

  • An older Clipper 24 with very slow or nearly neutral drop time may not hold static balance after tilting movements or physical contact
  • Balance loss consistently occurs in the direction of the tilt movement
  • A gimbal alignment issue can be diagnosed by performing a static balance test with a bubble level in two axes, then rotating the rig 180 degrees to see if balance is maintained
  • If the rig fails the 180-degree rotation test without tilting, gimbal misalignment is the likely cause and should be sent to the manufacturer for realignment and shimming
  • If the rig passes the static 180-degree test but loses balance when tilted, the problem may be slight movement in the top stage, post connectors, or fore-aft adjustment mechanism
  • Gimbal alignment was typically calibrated at the factory for approximately 3 to 3.5 second drop times, and using significantly slower drop times may exceed the rig's designed precision limits
  • The fore-aft travel adjustment mechanism can sometimes be corrected in the field with a custom tool in about 3 minutes

يعتمد على

  • The diagnosis applies specifically to the Clipper 24 model with tilt stage
  • Gimbal alignment issues are difficult and not recommended for field adjustment on this model
  • One participant mentioned experiencing similar symptoms on a Clipper 2 and suspected cable movement in the post rather than gimbal issues, but did not verify this theory
  • Very slow drop times may represent an operating condition beyond the rig's original design specifications
  • The actual cause was not definitively determined in the thread

القطع

Top Stage

المعدات أو القطع نفسها

  1. 2026تخفيض انخفاض الفولطية في قياس Steadicam® Zephyr كوخ لكاميرات البث عالية الطاقة.موضع خلافFacebookSteadicam operators group
  2. 2026Tiffen Steadicam® Elite sled (2026): build quality, power distribution, and load capacity versus Steadicam® Axis.FacebookSteadicam operators group
  3. 2026استعمل Zephyr مع الشاشة الاصلية لا توجد اشارة مع Sony FX6.FacebookSteadicam operators group
  4. 2026الاختراع بين الموجة Volt 2 وMK-V من المستوى gimbals: الأداء في الرياح، وزن الحفرة، الصيانة، تبديل النمط.موضع خلافFacebookSteadicam operators group
اقرأ النقاش الأصلياسأل عن هذا النقاشالإجابة تستشهد بالأرشيف