SteadiHub
2006منتدى Monitors

تصفية وإصلاح الأجهزة الإلكترونية غير العاملة

مضى على هذا 20 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.

ما توصّل إليه النقاش

  • الشاشة التي توقفت عن العمل وفجرت الصمامات قد يكون لديها أداة مفصّلة يمكن إعادة ربطها.
  • يجب أن يُحلّ القوس الذي يُسبّب في إتّصال سلكي مطلّق في سكّانٍ ثلاثيّ عن طريق إعادة بيع السلك إلى الفحم قبل أن يُحدث المزيد من المتاعب.
  • عندما تُظهر قوى الشاشة لكن لا تُظهر أيّ صورة وضوابط لا تُردّ، قد يكون المُحوّل الثلاثيّ أو المُحوّل للطيران مُخطئاً.
  • ظلم غرفة و كهرباء على الشاشة يمكن أن يكشف عن دوار أو شرارة مما يدل على فشل عنصري.
  • Tripler units may have been previously repaired with silicone sealant, and failed replacement capacitors within the tripler could be the source of new problems.
  • Black marks on a flyback transformer coil indicate previous arcing damage where wire insulation has melted.
  • Television repair shops may refuse to service these monitors due to discontinued parts availability.
  • HV units suitable for III and IIIA monitors can be sourced from electronics suppliers in some locations for approximately twenty to twenty-five dollars.

يعتمد على

  • The original monitor issue remained unresolved by the end of the thread.
  • No confirmation was provided that any repair solution actually restored functionality.
  • Suggested troubleshooting was based on general electronics knowledge rather than specific IIIA documentation.
  • High-resolution manual scans were mentioned but their availability depends on contacting specific individuals.
  • Parts availability varies significantly by geographic location.
اقرأ النقاش الأصلياسأل عن هذا النقاشالإجابة تستشهد بالأرشيف