2013منتدى Monitors
DIY construction plans for a monitor yoke bracket for Marshall 651 monitors
مضى على هذا 13 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.
ما توصّل إليه النقاش
- A yoke bracket can be constructed using CAD files to mount a Marshall 651 monitor on a sled system
- The yoke assembly consists of two side blocks bolted to a base block, with monitor blocks attached to the monitor itself using countersunk screws
- The pivot mechanism uses a 1/4 inch by 20 thread bolt with spring and nylon washers to allow monitor tilt adjustment
- The base block can be fitted with a 1/4 inch by 20 threaded hole for mounting to a sled
- Users report that the Marshall 651STX monitor is a cost-effective option that benefits significantly from use with a yoke mount
- The completed yoke bracket provides stable, adjustable monitor positioning without requiring repositioning the entire sled
يعتمد على
- The provided CAD plans lack detailed mounting documentation for attaching the yoke to sleds
- Assembly instructions are general and assume builder familiarity with machining and fabrication
- Only tested and used with Marshall 651STX monitors
- Thread was posted in 2013 and reflects equipment and practices from that era