ما توصّل إليه النقاش

• The Artemis sled features 3-pin Lemo power outputs; fatout details are found in the Artemis manual.
• The Volt battery also uses a 3-pin Lemo connector.
• Polarity must always be verified with a meter before connecting: some Artemis units (original Sachtler versus ARRI-built versions) have reversed pinouts, and one operator destroyed a monitor by connecting with incorrect polarity.
• The 4-pin video connector supplies both power and video signal for transmitters and monitors, suitable for low-mode monitor operation; however, the video line connects to the SD input rather than HD input (unconfirmed).
• Lemo half-moon shaped connectors are S-series; standard connectors are B-series; replacement connectors are available from Lemo distributors and reliable third-party manufacturers, and soldering is possible if pinout is known.
• Ready-made Artemis generation 1 cables are available from a cable specialist in Munich; custom cables from another supplier; used cables from dissolved Artemis 1 rigs.
• When in doubt, contact Tiffen or ARRI directly for clarification.

يعتمد على

• Pinout varies between Sachtler-built and ARRI-built Artemis units.
• Video connector video line function (SD versus HD input) remains unconfirmed.

المعدات في هذا النقاش

Artemisالكتالوج, Voltالكتالوج

القطع

Low Mode

المعدات أو القطع نفسها

1. 2026تقلص عدد خطوط الفيديو الخاصة بشركة BNC في ARRI Artemis 1 sled: أماكن العمل المؤقتة والحلول الدائمة.FacebookSteadicam operators group
2. 2026Volt جيلا، وما إذا كان النظام ضروريا على الإطلاقموضع خلافOperator practice
3. 2026EFP gimbal grip binding on the center rod: causes, clean, and repair versus replacement options.موضع خلافFacebookSteadicam operators group
4. 2026Rig setup for 180-degree immersive camera operation with Blackmagic URSA Cine Immersive: minimizing rig and monitor visibility in ultra-wide field of view.FacebookThe Steadicam Group