ما توصّل إليه النقاش

• Two RED cameras on a beam splitter rig was considered extremely challenging and impractical by most participants due to combined weight and complexity.
• A stripped-down single RED camera can weigh approximately 18 pounds, making two cameras with 3D rigging components exceed typical Steadicam payload capacity.
• The Element Technica RED 3D rig weighs about 100 pounds and is not practical for Steadicam mounting.
• A PACE 950 3D rig with two Sony F23 cameras weighed approximately 50 pounds and represented near maximum practical load for Steadicam operation.
• Custom counterbalance mechanisms at the bottom of Steadicam rigs can maintain perfect balance throughout 3D shots and prevent drift caused by operator adjustments.
• For the production of Avatar, a fiber optic cable system was used to connect 3D cameras to the base station instead of copper cables to reduce weight.
• The interocular distance and convergence control can be linked to focus control, allowing the focus puller to manage these parameters based on visual feedback rather than requiring a separate engineer.
• SI 2K Parallel Rig configurations have been successfully flown on Steadicam.
• Copper cabling on 3D rigs creates significant physical burden comparable to managing garden hoses.
• Flying dual RED cameras required balancing against available arm capacity, with operators reporting maxed-out equipment when attempting such configurations.

يعتمد على

• Experiences shared are from specific productions and particular camera models; results may vary with different equipment combinations.
• The Avatar production information represents a high-budget production environment and may not reflect constraints of smaller productions.
• Discussion participants had varying arm systems (G70 mentioned) which have different weight ratings.
• Some specific rig weights were estimated rather than precisely measured.
• The practical feasibility depends heavily on the specific Steadicam arm model and operator skill level.

المعدات في هذا النقاش

G-70الكتالوج, FI+Z, BFD

المعدات أو القطع نفسها

1. 2025History of wireless focus and lens control systems for Steadicam®: from cable-based Cinema Products and Seitz to Preston digital, and European solutions by Chrosziel, cmotion, and ARRI.FacebookSteadicam operators group
2. 2023تقييم الأداء والقيمة لنظم تثبيت المفاعلاتGeneral Discussion
3. 2023معدات الدعم والمعدات الاحتياطية لـ Steadicam® مشغلا: القائمة ذات الأولوية واعتبارات الميزانيةFacebookSteadicam operators group
4. 2023شنق Tiffen و G50X ذراعاً على مركب رصيفي بدون رصينة؛ مدى توافر arm posts أطول.FacebookThe Steadicam Group