SteadiHub
2004منتدى Batteries/Power

المسائل المتعلقة بتوافق القوة مع البطاريات ديونيك وإيفيرتز

مضى على هذا 22 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.

موضع خلافاختلف المشاركون ولم يصلوا إلى خلاصة. اقرأ النتائج على أنها مواقف، لا إجابة.

ما توصّل إليه النقاش

  • The Varicam should be used with a standard V-mount rapid release plate rather than a heavy sliding baseplate designed for film cameras, weighting approximately 6 pounds.
  • وتتفق البطاريات ديونية بوجه عام مع الفاريكام، حيث توزعها المنازل المستأجرة بصورة روتينية دون مشاكل.
  • The Varicam draws approximately 38 watts during normal operation but experiences significant power spikes during startup that can exceed this baseline draw.
  • Lithium-ion batteries have protection circuits programmed to handle inrush current, and different manufacturers program these circuits differently, which can cause compatibility issues with equipment that draws high startup power.
  • When powering both the Varicam and an Evertz downconverter, power must be supplied directly to the downconverter from an onboard camera battery rather than through the camera's 4-pin input.
  • A loose power cable connection at the battery mount can cause electrical faults including sparks and temporary readout failures in batteries.
  • Some Dionic batteries displayed scrambled video output or went unresponsive when used with a particular Varicam and Evertz setup, while larger capacity Hytron batteries worked without issues.

يعتمد على

  • The specific cause of compatibility between certain Dionic batteries and the Varicam with Evertz downconverter remains unclear and may be equipment-specific.
  • The original poster did not test whether the issue was caused by the Evertz downconverter alone or the combination with the Varicam.
  • No information about whether additional onboard lights were in use during the problematic power attempts.
  • The loose cable issue was identified but not confirmed as the root cause of the earlier battery readout problems.

القطع

Base Plate

المعدات أو القطع نفسها

  1. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest work flow.FacebookSteadicam operators group
  2. 2026تبدل الكاميرا بين الشاحنات الثلاثية والأجهزة: أرخص ترقية لمعظم المشغلين لا تجعلOperator practice
  3. 2026تشغيل Steadicam® Zephyr دون Volt: drop time، مراقبة الأفق، وتأثير توزيع الوزن الأعلى على التوازن.موضع خلافFacebookSteadicam operators group
  4. 2026لوحات تكييف الكاميرات ونظم تركيب المثبتات لإبقاءها في مجموعة مواد مشغلةGeneral Discussion
اقرأ النقاش الأصلياسأل عن هذا النقاشالإجابة تستشهد بالأرشيف