ما توصّل إليه النقاش

• The M1 gimbal has a larger post diameter than the GPI Pro gimbal by approximately 1.5 inches, making them incompatible without modification.
• A spacer could theoretically be used to adapt an M1 gimbal to a GPI Pro post, but the required spacer thickness would be very small (around 0.06 inches), raising concerns about stability and slippage.
• GPI Pro gimbals can be fitted to an M1 Volt sled as an alternative solution.
• The manufacturer was expected to offer adapter solutions at NAB (a major industry trade show).

يعتمد على

• No confirmed adapter product was mentioned as existing at the time of discussion.
• The spacer approach was presented as theoretical and untested, with concerns about its reliability.
• The discussion does not specify exact measurements or confirm whether any adapter was actually released after NAB.

المعدات في هذا النقاش

Voltالكتالوج

المعدات أو القطع نفسها

1. 2026Volt جيلا، وما إذا كان النظام ضروريا على الإطلاقموضع خلافOperator practice
2. 2026Buying strategy for a 25,000 USD entry-level rig: used Artemis-1 with Flowcine X-Arm against Rever-Evo Sled, and the case for learning on budget equipment firstموضع خلافFacebookThe Steadicam Group
3. 2026Lemo connectors on the ARRI Artemis sled: fatout, polarity verification, and powering low-mode monitors and Volt bat.FacebookSteadicam operators group
4. 2026Intry-level stabilizationr strategy on a 15,000 USD budget: Rever EVO against used Artemis 2 or M2 plus Volt, in a market with limited secondhand availability.موضع خلافFacebookThe Steadicam Group