2010منتدى Brackets/Widgets
Pro2 Landing Pad 2.0 modifications for weight reduction and versatile card positioning
مضى على هذا 16 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.
ما توصّل إليه النقاش
- The revised landing pad design uses interchangeable mounting plates with standard tapped holes, allowing users to attach different plate configurations to the base unit.
- The landing pad with a 7-inch pro plate weighs just under one pound, while the base unit alone weighs approximately 0.5 pounds.
- The landing pad provides a stable, flat surface for setting down the sled without placing weight directly on battery connectors.
- The modular foot design enables battery repositioning strategies such as moving the front battery lower for top-heavy camera rigs or forward for monitor placement.
- Mounting a battery on a dovetail plate via an aluminum bracket can help distribute weight and modify the rig's center of gravity for different camera configurations.
- Heavier camera packages benefit more from the landing pad's weight distribution capabilities than lighter setups under 30 pounds.
- Image flipping in post-production can sometimes replace low-mode wedges and related mounting hardware, potentially saving weight and setup time.
يعتمد على
- This discussion focuses on a specific prototype and production design from a single manufacturer around 2010.
- The battery positioning examples provided were experimental setups and not necessarily recommended for standard use.
- Weight savings calculations are specific to particular battery types and accessory combinations mentioned in the thread.
- Some users expressed caution about setting rigs down on battery connectors despite the stated design intention.
- The homebrew dovetail bracket solution described was a temporary prototype, not a finished product design.
القطع
المعدات أو القطع نفسها
- 2026Vest قطرة: ما الذي يُخفّض جورب الذراع يشتريه فعلاً، وما يُكلّف على القمةOperator practice
- 2026القضاء على الاهتزاز مع ARRI ALEXA 35 في Steadicam®: خيارات الرفع الصلب للطبقات لتجاوز نظام dovetailFacebookThe Steadicam Group
- 2026Lemo connectors on the ARRI Artemis sled: fatout, polarity verification, and powering low-mode monitors and Volt bat.FacebookSteadicam operators group
- 2026تبدل الكاميرا بين الشاحنات الثلاثية والأجهزة: أرخص ترقية لمعظم المشغلين لا تجعلOperator practice