SteadiHub
2005منتدى Arms

تحديات الوزن والمناولة للكاميرات الذهبية الثانية Panavision في Steadicam مركبة

مضى على هذا 21 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.

ما توصّل إليه النقاش

  • The Panavision Gold II is significantly heavier than expected and causes physical strain during extended handheld use, with operators reporting arm pain and numbness after relatively short periods of work.
  • ويمكن أن يزن تحويل الذهب الثاني المهيأ بالكامل مع صندوق مات ومحركات و عدسات وملحقات يتراوح وزنه بين 35 و 42 رطلاً تبعاً لاختيار العدسات، وهو ما يتجاوز عتبة الراحة العملية للعمليات المستمرة.
  • وتُقدَّر تركيبات الذهب الثاني غير المُحوَّلة بمجموعات بصرية كاملة وبلوحات قياسية من طراز dovetail بما يتجاوز 50 رطلاً، مما يُحدِث خطراً مفرطاً على فشل المعدات وإصابة المشغل.
  • توزيع وزن الكاميرا يميل إلى أن يكون ثقيلا، مما يجعل من الصعب تحقيق مركز ملائم من التوازن الجماعي في gimbal مما يؤدي إلى لقطات غير ثابتة.
  • Spring components in 3A arms have been known to fail under the stress of carrying heavily configured Gold II systems, with springs shooting through the arm cover.
  • Operators who have used both Panavision Gold II and Moviecam SL note significant differences in weight and handling characteristics between the two cameras.
  • The lighter-weight zoom lenses available for the Gold II compromise image quality compared to prime lens alternatives.
  • Attending a camera prep at the rental facility before the first use is recommended to become familiar with the camera's handling characteristics.

يعتمد على

  • Reports are based on 1990s-2000s equipment configurations and may not reflect modern setups.
  • Arm failures occurred with specific 3A sled configurations and may vary with other arm models.
  • Weight measurements were taken by individual operators using various scales and methods, not all precisely documented.
  • The comparison between Gold II and Moviecam SL was anecdotal rather than systematic.
  • No standardized testing or manufacturer specifications are referenced to verify claims.

القطع

Low Mode

المعدات أو القطع نفسها

  1. 2026Finding a bright (1500–2000 nits) low-mode monitor with recording and SDI I/O to replace a defective Transvideo Starlite.موضع خلافFacebookSteadicam operators group
  2. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rodmounts and CamJam mounts to minimize vibrationsموضع خلافSteadiHub
  3. 2026Lemo connectors on the ARRI Artemis sled: fatout, polarity verification, and powering low-mode monitors and Volt bat.FacebookSteadicam operators group
  4. 2026الاختراع بين الموجة Volt 2 وMK-V من المستوى gimbals: الأداء في الرياح، وزن الحفرة، الصيانة، تبديل النمط.موضع خلافFacebookSteadicam operators group
اقرأ النقاش الأصلياسأل عن هذا النقاشالإجابة تستشهد بالأرشيف