ما توصّل إليه النقاش

• The 4-pin XLR cable supplied by the sled manufacturer is wired for 12V only and cannot deliver 24V power
• An Alexa camera body weighs nearly 14 pounds, and adding accessories like lenses, focus motors, transmitters and receivers can easily exceed 24 pounds total
• A Zephyr stabilizer can support approximately 25 pounds on the camera stage with an overall arm lift capacity around 36 pounds maximum
• Using 24V power delivery is preferable to 12V as it reduces strain on batteries
• Custom cable fabrication from specialized vendors is necessary to properly connect Fischer 2-pin Alexa battery connectors to the 3-pin Lemo sled connectors
• An Alexa can be successfully flown on a Zephyr when configured with lightweight lenses, onboard focus system mounted to sled dovetail via carbon rods, clip-on mattebox, and the rear battery removed

يعتمد على

• The power distribution system has not been fully tested and detailed specifications from manufacturers are unclear or inconsistent
• Successful operation depends heavily on careful weight management and component selection
• The monitor burnout incident reported suggests potential power distribution issues with multiple accessories that were not fully resolved in the discussion

المعدات في هذا النقاش

Artemisالكتالوج, Zephyrالكتالوج

المعدات أو القطع نفسها

1. 2026لِماذا a 150 Wh بطارية في sled يَقُودُ آلةَ التصوير لفقط -20 دقيقةِ مقابل إثنان إلى ثلاث مراتِ أطولِ عندما صُمّمتْ على الجسمِ، و كَيفَ يُمْدّدُ الجرّارَ.موضع خلافFacebookThe Steadicam Group
2. 2026Steadicam® A-30 lower arm segment stiffness and squeaking after warranty service; bearing ring contact hypothesis.FacebookSteadicam operators group
3. 2026(أ) الانتقاء بين رفع مستوى مجموعة مواد بروفيد-2 القديمة أو الاستثمار في جهاز مهني: النهج الأول لحلقة العمل مقابل النهج الأول للمبتدئين في المعدات.موضع خلافFacebookSteadicam operators group
4. 2026Lemo connectors on the ARRI Artemis sled: fatout, polarity verification, and powering low-mode monitors and Volt bat.FacebookSteadicam operators group