ما توصّل إليه النقاش

• A practice cage can be built using two pieces of square aluminum tubing filled with cement to create a weighted base, with dimensions around 45cm and 30cm lengths and 4mm fishness, weighting approximately 10kg.
• لوحة القاعدة يجب أن تكون في مركز الكتلة، مثقوبة بالثقوب المناسبة، وخيط مع 3/8 بوصات لربط لوحة steadicam.
• ويستخدم تصميم بديل لوحتين من الألومنيوم مع تلفات من الفولاذ بينهما، مع تدنيس الدروع بمسافة 280 ملم لاستيعاب الكاميرات المدمجة، والوزن القابل للتعديل بمقاس متفاوت.
• The XL1 camera has a shallow 1/4-20 thread hole in its base that can be damaged if screw length is too long, potentially piercing the circuit board inside.
• A practice cage can incorporate a camera mounting plate positioned above the base to simulate lens height of full-size cameras.
• Diving weights can be attached or screwed into the top of a cage to increase total weight for practice.
• Quality of materials matters significantly when building custom parts locally, as material defects could result in equipment failure and accidents.

يعتمد على

• The XL1 camera limitation applies specifically to that model, though similar issues may occur with other cameras.
• Suggested cage designs and weights are based on individual builder experience and may vary based on available materials and local construction capabilities.
• Specific spacing distances for threaded mounting holes were requested but not fully resolved in the discussion.
• The advice about material quality is general and not tied to specific suppliers or grades tested.

القطع

Base Plate

المعدات أو القطع نفسها

1. 2026تشغيل Steadicam® Zephyr دون Volt: drop time، مراقبة الأفق، وتأثير توزيع الوزن الأعلى على التوازن.موضع خلافFacebookSteadicam operators group
2. 2026تبدل الكاميرا بين الشاحنات الثلاثية والأجهزة: أرخص ترقية لمعظم المشغلين لا تجعلOperator practice
3. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest work flow.FacebookSteadicam operators group
4. 2026لوحات تكييف الكاميرات ونظم تركيب المثبتات لإبقاءها في مجموعة مواد مشغلةGeneral Discussion