SteadiHub
2009منتدى Brackets/Widgets

PRO 2 landing pad and weight plate system for camera stabilizers

مضى على هذا 17 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.

ما توصّل إليه النقاش

  • A flat landing pad with dovetail attachment allows PRO 2 sled operators to rest their rig on equipment boxes between shots without applying pressure to the batteries.
  • The dovetail design accommodates standard accessories like antlers for low-mode work and allows a weight plate slider system to attach.
  • The landing pad mounts to the curved battery rails using three rods and provides a solid connection while allowing Dionic and small Hytron batteries to fit on the front.
  • The initial version weighed approximately 20 ounces and could be customized by hollowing out material or adding IDX plate attachments for specific user needs.
  • A redesigned version 2.0 was made lighter and smaller with longer side rails to accommodate various battery sizes and different PRO 2 sled versions.
  • An alternative approach uses an Anton Bauer hot swap adapter that switches power between batteries sequentially rather than running them in parallel.
  • The Anton Bauer hot swap device has built-in electronics that allow only one battery to supply power at a time until exhausted, then automatically switches to the next battery.
  • Some operators successfully modified Anton Bauer hot swap units by rewiring them to run two batteries in parallel for increased amperage, though this made the sled wider.

يعتمد على

  • The first production run received feedback that the design was heavier and bulkier than some operators preferred for rigs requiring minimal weight.
  • The Anton Bauer approach has design limitations including incompatibility with some battery models due to wireless bracket attachments that protrude from the unit.
  • Battery compatibility varies across different PRO 2 sled versions produced over time, requiring design adjustments to the side rail length.
  • The parallel battery modification of the Anton Bauer device requires custom rewiring and is not an officially supported configuration.

القطع

Low Mode

المعدات أو القطع نفسها

  1. 2026Vest قطرة: ما الذي يُخفّض جورب الذراع يشتريه فعلاً، وما يُكلّف على القمةOperator practice
  2. 2026Low-mode رصد الاختيار من أجل Volt جهاز حفر الدماغ: أداء الطوارئ البالغ Transvideo Starlite مقابل البدائل الحالية.موضع خلافFacebookThe Steadicam Group
  3. 2026Lemo connectors on the ARRI Artemis sled: fatout, polarity verification, and powering low-mode monitors and Volt bat.FacebookSteadicam operators group
  4. 2026Rig setup for 180-degree immersive camera operation with Blackmagic URSA Cine Immersive: minimizing rig and monitor visibility in ultra-wide field of view.FacebookThe Steadicam Group
اقرأ النقاش الأصلياسأل عن هذا النقاشالإجابة تستشهد بالأرشيف