SteadiHub
2011منتدى 3D Steadicam

كاميرا مزدوجة لـ(أليكسا) على Steadicam لـ3D

مضى على هذا 15 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.

ما توصّل إليه النقاش

  • مطاردة كاميراتين كاملتين من طراز أليكسا على سلاح واحد Steadicam يتطلب وظيفة معززة حسب الأعراف، حيث تنحني الوظائف الموحدة تحت الوزن
  • A dual-Alexa rig weights approximately 100 pound and benefits from heavy batterypacks mounted low to improve balance
  • يمكن تركيب المكبس على بطن فيشر 10 مع مقعد سباق وإطار أنابيب، مما يمكّن كلا من low-mode وعملية متنقلة
  • ويجب أن تُعدَّل الصعاب الربيعية على نحو سليم بين الأسلحة المتعددة للحفاظ على التوازن المتناسق عند حمل كاميرات مزدوجة
  • ويصبح توزيع الطاقة أمرا بالغ الأهمية مع وجود كاميرات مزدوجة؛ وتشمل الحلول تشغيل الكابلات على طول أغطية الكتف أو استخدام تشكيلات البطاريات الموسعة
  • The Freestyle rig demonstrates significant flexing under dual-Alexa loads, requiring gentle operation to maintain camera calibration
  • Gimbal yoke and post integrity are stressed by 100+ pound loads; reinforced case-hardened posts reduce but do not eliminate bending
  • Mirror box flare issues increase with dual-camera configurations and require mitigation strategies

يعتمد على

  • The described solutions were developed for specific Alexa models before the Alexa M became available
  • Vest-mounted configurations require awkward gimbal repositioning before docking and limit the dual-arm advantage to cart and dolly mounting
  • The reported flexing behavior of Freestyle rigs under dual-camera loads suggests potential calibration drift during operation
  • No definitive maximum load capacity numbers provided for gimbal yokes under these extreme conditions
  • Operator ergonomics and spine strain become severe factors at 100+ pounds, making this setup primarily suitable for cart-based operation

المعدات في هذا النقاش

G-70الكتالوج

القطع

Low Mode

المعدات أو القطع نفسها

  1. 2026الاختراع بين الموجة Volt 2 وMK-V من المستوى gimbals: الأداء في الرياح، وزن الحفرة، الصيانة، تبديل النمط.موضع خلافFacebookSteadicam operators group
  2. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rodmounts and CamJam mounts to minimize vibrationsموضع خلافSteadiHub
  3. 2026Low mode وقلب الصورة: ما التحقق من الكاميرا قبل اليومOperator practice
  4. 2026Rig setup for 180-degree immersive camera operation with Blackmagic URSA Cine Immersive: minimizing rig and monitor visibility in ultra-wide field of view.FacebookThe Steadicam Group
اقرأ النقاش الأصلياسأل عن هذا النقاشالإجابة تستشهد بالأرشيف