2017Forum News, Events, Workshops
Technische Spezifikationen und Fähigkeiten des Steadicam M1 Volt motorisierten Gimbal Systems
Was die Diskussion ergab
- Der M1 Volt war für 6.500 US-Dollar ab Werk erhältlich, wobei die Einheiten bereits ab 2017 ausgeliefert wurden.
- Der M1 Volt Gimbal kann für ältere Sled-Modelle wie Archer, Ultra, Clippers und Shadows durch Gimbal-Modifikationen angepasst werden.
- Die M1 Volt erfordert keine Fernbedienung für motorisierte Bühnenfunktionen, obwohl vorhandene Fernbedienungen von früheren Modellen immer noch verwendet werden können, wenn verfügbar.
- Der Gimbal kann unausgeglichene Sleds einigermaßen gut handhaben, obwohl die dynamische Balance die Leistung vor allem für große Bewegungen und Peitschenpfannen verbessert.
- Neigungs- und Rollgeschwindigkeiten sind unabhängig voneinander variabel und reichen von sehr langsam bis ziemlich schnell.
- The gimbal gradually reduces motor assistance starting around 45 degrees of tilt when the rig is rested on the shoulder, and roll assistance reduces around 5 degrees.
- The system engages instantly when transitioning from shoulder rest to active shooting and gradually increases motor assistance.
- Motor and belt components require minimal ongoing work during normal operation and belt life is expected to be very long, though belts are easily replaceable worldwide.
- The system consumes minimal power during normal operation, drawing approximately 2 amps only when needed, and should not significantly impact battery life.
- Gimbal centering is factory-set to match the M1 system specifications and the gimbal can tolerate some off-center conditions with slightly increased power draw.
- The gimbal rarely exhibits confusion or drift during operation, though extreme continuous accelerations like on a rotating platform might theoretically cause level drift.
- Motors are not damaged if the system is set to hold vertical position while the rig is manually held at a different angle.
- Exposed drive gears and toothed belt should be temporarily covered with a protective skirt in dusty or wet conditions similar to those requiring camera protection.
Hängt ab von
- Compatibility with the PRO 1.5 inch post was under investigation at the time of discussion with no specific timeline provided.
- Motor strength against wind pressure depends on the wind shadow profile of the specific rig configuration.
- Information about maximum motor pressure specifications in pounds was not clearly quantified in the discussion.
- The gimbal centering procedure and any manual adjustments needed are not explicitly detailed.
- Long-term maintenance intervals and replacement schedules for motors and belts beyond general descriptions were not specified.