SteadiHub
2009Forum Steadi-Newbies

Dynamisches Gleichgewicht auf einer Steadicam Pilot mit einer Panasonic HMC151-Kamera, wenn die Standard-3/4-Richtlinie nicht gilt

17 Jahre alt. Geräte und Preise können sich seitdem geändert haben.

Was die Diskussion ergab

  • Die 3/4-Zoll-Schwerpunktposition hinter dem Sled-Pfosten ist ein Ausgangspunkt für größere Rigs mit deutlich erhöhten Monitoren, keine feste Anforderung für alle Setups.
  • Kleinere Geräte wie der Pilot erfordern, dass der Schwerpunkt der Kamera viel näher an der Mittellinie des Hauptpfostens positioniert ist, da der Abstand zwischen Monitor und Batteriegewichtsverteilung verringert ist.
  • Dynamic balance is achieved by adjusting camera position back and monitor position forward in small increments while spin testing at normal panning speeds.
  • The monitor cable on the Pilot can be unwound and repositioned through the monitor bracket to extend the monitor farther from the sled centerline, increasing available adjustment range.
  • Placing the monitor and battery at their outermost possible positions improves setup repeatability and speeds up achieving dynamic balance.
  • Adding weights like Merlin units to the bottom of the rig can stabilize camera wavering during forward motion.
  • Trimming for headroom by adjusting the stage forward or aft throws the rig out of both static and dynamic balance.

Hängt ab von

  • The Pilot has limited flex in monitor extension compared to larger rigs, restricting the range of possible adjustments.
  • The relationship between monitor height, battery position, and camera position was not fully explained in the manufacturer guide for this specific rig model.
  • Results may vary depending on the specific camera weight and monitor specifications used.

Bauteile

Monitor Bracket

Dieselben Geräte oder Bauteile

  1. 2026Rigging eines RED Komodo 6K auf einem CAME-TV Steadicam® Sled für verbesserte Trägheit und Bedientechnik.UmstrittenFacebookSteadicam operators group
  2. 2026Montage eines Mo-Sys LED-Wandverfolgungssensors auf ARRI Trinity 2 mit nach oben gerichtetem Sensor für die virtuelle Produktion.FacebookArri Artemis Trinity
  3. 2026Modernisierung Steadicam® PRO Sled: Gen-2 Batteriehalter Nachrüstung und Universal Monitor Bracket am Rohrkragen.FacebookSteadicam operators group
  4. 2026Finding a bright (1500–2000 nits) low-mode monitor with recording and SDI I/O to replace a defective Transvideo Starlite.UmstrittenFacebookSteadicam operators group
Originaldiskussion lesenFrage zu dieser DiskussionDie Antwort nennt ihre Quellen