SteadiHub
2008Forum Steadi-Newbies

Abgleich- und dynamische Abstimmungsverfahren für Flyer Kamera Sled

18 Jahre alt. Geräte und Preise können sich seitdem geändert haben.

Was die Diskussion ergab

  • Die Sled sollte leicht frontlastig sein, ohne dass eine Kamera angebracht ist, aber dies ist kein praktisches Problem, da eine Kamera während des Betriebs immer montiert wird.
  • Kameramarke und -form sind für das Gleichgewicht irrelevant; nur die Gesamtmasse und die Lage des Schwerpunkts sind wichtig.
  • A properly balanced rig should respond to forward, backward, and sideways thrust movements without tipping or rotating.
  • To find a camera's center of gravity, rig it fully as it will be flown, then balance it on a pencil point and mark that location.
  • Mount the camera so its center of gravity sits directly over the sled's center post to achieve approximately eighty percent of the way to dynamic balance.
  • Battery position should be fine-tuned using the battery mount swivel to achieve front-to-back balance.
  • Final adjustments to dynamic balance come from the adjustment knobs under the dovetail plate.
  • A rig that is too bottom-heavy may cause the sled to kick or behave unpredictably during thrust movements, and increasing drop time to around three seconds can help address this issue.
  • Increasing drop time for a bottom-heavy rig requires more deliberate horizon control during operation but can improve overall handling characteristics.

Hängt ab von

  • The procedures described were shared by experienced operators but were not presented as formally tested methods.
  • Advice about drop time adjustment is anecdotal and specific tuning may vary by individual rig configuration.
  • The discussion does not address all possible camera models or mounting configurations.
  • Dynamic balance procedures require hands-on practice and workshop instruction for optimal results.

Bauteile

Dovetail Plate

Dieselben Geräte oder Bauteile

  1. 2026Festziehen eines losen Schnellverschlusshebels auf der Top Stage Dovetail-Platte und Verhindern eines Kamerarutschens während der Schulteroperation.UmstrittenFacebookThe Steadicam Group
  2. 2026Eliminieren von Vibrationen mit dem ARRI ALEXA 35 auf Steadicam®: starre Montageplattenoptionen, um das Dovetail-System zu umgehenFacebookThe Steadicam Group
  3. 2026Wechseln der Kamera zwischen Stativ und Rig: das billigste Upgrade, das die meisten Betreiber nie machenOperator practice
  4. 2026Umgang mit Gewichtsbeschränkungen beim Fliegen von großformatigen Filmkameras mit schweren anamorphen Objektiven auf einem Steadicam-RigGeneral Discussion
Originaldiskussion lesenFrage zu dieser DiskussionDie Antwort nennt ihre Quellen