2015Forum Monitors
Generation 2 Cinemonitor akzeptiert kein SD-Komposit-Videosignal
Was die Diskussion ergab
- Der Comp 2-Eingang des Gen 2-Modells verwendet ein 8-poliges Steckverbinderformat.
- Einige Einheiten hatten einen defekten Widerstand auf der Hauptplatine, der den analogen Videoeingang verhinderte und eine Reparatur auf Boardebene erforderlich machte.
- A full reset should be attempted before sending the monitor in for service.
- Cross-converting from composite to SDI using an external converter box is a potential workaround.
- SD composite video input should work on properly functioning Gen 2 units.
- It is worth verifying that the video source is truly SD and not HD, as this confusion can occur on set.
Hängt ab von
- The resistor defect was noted as affecting only some units, not all Gen 2 monitors.
- The external converter solution adds cost and complexity rather than fixing the root issue.
- One user reported a Comp 2 input failure after six years of reliable operation, suggesting possible component degradation over time.
- The Gen 2 is described as significantly different from Gen 1, limiting cross-model troubleshooting relevance.