2010Forum Cameras (Film/Video/HD)
Balancieren einer JVC GYHM-700 Kamera auf einem Steadicam Pilot Rig
16 Jahre alt. Geräte und Preise können sich seitdem geändert haben.
Was die Diskussion ergab
- Eine Kamera mit einem Gewicht unter 10 Pfund sollte auf einer Steadicam Pilot balancieren, so dass das Gewicht allein nicht das Problem ist, wenn das Setup in diesen Bereich fällt.
- Das Vorwärtsschwimmen des Rigs wird durch Verstellen der oberen Daumenschraube auf der Socket Block im Uhrzeigersinn gesteuert, bis sie nicht mehr wegdriftet.
- The bottom socket block screw must be threaded all the way in to establish a baseline before fine-tuning with the top screw.
- Side-to-side drift is managed by starting with the bottom bolt fully threaded in and backing it off about one quarter turn, then adjusting the top bolt starting from fully in and threading out approximately three full turns.
- If the rig continues to float left after initial screw adjustments, further backing out the top bolt provides correction; if it floats right, threading it in provides correction.
- Operator stance and posture significantly affect balance, as shoulder angle and hip position change the effective balance point of the rig.
- Achieving a balanced configuration may require multiple attempts because the operator's body position changes how the rig behaves, even with the same hardware settings.
Hängt ab von
- The specific camera model mentioned is the JVC GYHM-700, and guidance may not transfer directly to other camera models or weights.
- The Steadicam Pilot model is referenced; other Steadicam models may have different adjustment mechanisms.
- No resolution is documented for whether this particular camera and rig combination ultimately worked successfully.
- Advice relies on trial-and-error methodology and operator feel rather than a standardized calibration procedure.