Was die Diskussion ergab

• Der Mittelpfosten des Flyer Sled hat einen Innendurchmesser von nur 11 mm, der zu schmal ist, um Standard-FireWire-Steckverbinder (6-Pin oder 4-Pin) aufzunehmen.
• Routing cables externally along the front of the sled from the camera to the monitor works effectively when kept taut and dressed properly, avoiding interference with gimbal movement.
• External cables wrapped around the center post cause binding and interference during panning because they must remain loose to avoid contact with the gimbal mechanism.
• If internal cable routing is attempted on a Flyer, the existing connector block at the bottom of the post takes up most of the internal space and would need to be removed and rewired.
• Mounting external FireWire cables straight down the front of the sled (rather than wrapped around the post) and securing them with tape or velcro prevents balance problems during operation.
• The Flyer sled supports a maximum payload of 15 pounds for camera equipment.
• The Flyer includes a built-in 7-inch 16x9 monitor and can power cameras via its own battery with appropriate connectors.

Hängt ab von

• Disassembling a Flyer sled to modify internal cabling voids the warranty and risks expensive damage.
• Any internal cable modification would render the sled non-standard and difficult to resell.
• Running cables externally affects spin balancing, requiring balance adjustments to be done before cables are reattached.
• The post is too narrow to fit standard FireWire connectors; only the thinnest cables without factory connectors might fit if connectors were installed afterward.

Bauteile

Monitor Bracket

Dieselben Geräte oder Bauteile

1. 2026Finding a bright (1500–2000 nits) low-mode monitor with recording and SDI I/O to replace a defective Transvideo Starlite.UmstrittenFacebookSteadicam operators group
2. 2026Modernisierung Steadicam® PRO Sled: Gen-2 Batteriehalter Nachrüstung und Universal Monitor Bracket am Rohrkragen.FacebookSteadicam operators group
3. 2026Rigging eines RED Komodo 6K auf einem CAME-TV Steadicam® Sled für verbesserte Trägheit und Bedientechnik.UmstrittenFacebookSteadicam operators group
4. 2026Montage eines Mo-Sys LED-Wandverfolgungssensors auf ARRI Trinity 2 mit nach oben gerichtetem Sensor für die virtuelle Produktion.FacebookArri Artemis Trinity