2013Forum Sled
Umverdrahtung der Energieverteilung auf einer ersten Generation Steadicam Flyer Sled, um moderne Steckverbinder und mehrere Batteriehalterungen zu verwenden
13 Jahre alt. Geräte und Preise können sich seitdem geändert haben.
Was die Diskussion ergab
- A three-pin LEMO connector provides better compatibility than a two-pin connector and enables future 12V/24V switching capability if needed.
- When connecting two battery mounts to a single power output, a diode must be installed in-line to each battery to prevent back-charging problems.
- Wire gauge of 14 AWG is suitable for running power up the center post from battery mounts to the connector.
- The gray arm indicates a first generation Flyer, which functions identically to the second generation model.
- A three-pin LEMO connector for a Steadicam Flyer is part number EGG.0B.303.CLL.
- An alternative approach is to use separate P-tap breakout boxes at different points on the sled to distribute power to multiple devices from separate battery sources.
- Modern cinema cameras rarely require 24V power, making the 24V capability of a three-pin setup optional rather than essential.
Hängt ab von
- The exact pinout configuration for 12V and 24V on a three-pin LEMO was not fully confirmed in the discussion.
- No detailed wiring schematic was provided for connecting two battery mounts in parallel with diode protection.
- The suitability of 14 AWG wire assumes standard power requirements and was not verified for all use cases.
- The alternative P-tap approach was described briefly but not detailed comprehensively.