SteadiHub
2005منتدى Batteries/Power

إنتاج فولتاج من بطاريات الليثيوم غير الساحلية في نظم الطاقة المتعددة الأليوب والتوافق مع كاميرات السينما وأجهزة الدخول

مضى على هذا 21 سنة. قد تكون المعدات والأسعار قد تغيّرت منذ ذلك الحين.

ملاحظة (حتى أكتوبر 2026)لم يعد كورت أو. شالر، مطوّر أنظمة Artemis وTrinity، يعمل لدى ARRI منذ نهاية عام 2025. على حد علمنا، لا يوجد لدى ARRI حاليًا فريق مخصص ولا جهات اتصال رسمية لأنظمة المثبّتات. نرى أن مستقبل هذا الخط غير مؤكد. إذا كنت تشتري جديدًا، فاحصل مسبقًا من ARRI على تأكيد مكتوب بمدة ضمان الخدمة وقطع الغيار. اطلب من الشركة المصنّعة فحص الأجهزة المستعملة قبل الشراء.

ما توصّل إليه النقاش

  • Fully charged 14.4V V-lock lithium batteries can output up to 16-17V before any load is applied, resulting in 31-32V when two bricks are combined in series.
  • The initial high voltage from freshly charged batteries drops significantly once accessories are powered on, typically falling to 29-30V under load.
  • Arri 24V cameras generally tolerate high voltages well when freshly charged, while older 12V cameras and some models like Moviecam require careful attention to prevent damage.
  • Accessory ports on the Artemis power distribution box supply 12V regardless of whether the system is configured for 12V or 24V mode.
  • Most cinema accessories including follow focus and wireless video systems operate on 12V or within a 12-30V range, making them compatible with both voltage configurations.
  • Using four batteries in a two-plus-two series configuration provides sufficient power and weight distribution for operating a 35mm camera at high frame rates while allowing daily battery rotation.

يعتمد على

  • The voltage regulation issue may vary depending on the specific battery manufacturer and charger used.
  • The reported video tap problem with the 435 camera was not reproduced by other users, suggesting it may be specific to certain equipment configurations or setups.
  • Experience is limited to specific battery models and camera models mentioned in the discussion.
  • The multi-battery modification described requires custom machining work to implement properly.

المعدات في هذا النقاش

Artemisالكتالوج

القطع

Follow Focus

المعدات أو القطع نفسها

  1. 2026Intry-level stabilizationr strategy on a 15,000 USD budget: Rever EVO against used Artemis 2 or M2 plus Volt, in a market with limited secondhand availability.موضع خلافFacebookThe Steadicam Group
  2. 2026Lemo connectors on the ARRI Artemis sled: fatout, polarity verification, and powering low-mode monitors and Volt bat.FacebookSteadicam operators group
  3. 2026لِماذا a 150 Wh بطارية في sled يَقُودُ آلةَ التصوير لفقط -20 دقيقةِ مقابل إثنان إلى ثلاث مراتِ أطولِ عندما صُمّمتْ على الجسمِ، و كَيفَ يُمْدّدُ الجرّارَ.موضع خلافFacebookThe Steadicam Group
  4. 2026Los power on Trinity 2 / Artemis 2 with large cameras (A35, Venice): causes and battery solutions.موضع خلافFacebookArri Artemis Trinity
اقرأ النقاش الأصلياسأل عن هذا النقاشالإجابة تستشهد بالأرشيف