SteadiHub
2010Forum Steadi-Newbies

Balancing einer Canon 5D Kamera auf einer Steadicam Sled erfordert zusätzliches Gewicht

16 Jahre alt. Geräte und Preise können sich seitdem geändert haben.

Was die Diskussion ergab

  • A Canon 5D alone is too light to properly balance on a Steadicam sled, requiring added counterweight to pull the arm down into level position
  • Cast iron weights can be temporarily attached to the sled shaft as a quick solution for balancing
  • Custom steel weight bars with threaded holes along their length, weighing around 12 pounds, can be machined and fitted with Manfrotto quick release adapters for permanent balancing solutions
  • Diving weights mounted on either side of a camera bracket can achieve proper balance and weighting
  • Commercial weight cages with modular weighted plates in various denominations offer flexibility for different camera and lens configurations
  • Canon lenses with fly-by-wire focusing mechanisms present significant challenges for focus pulling on Steadicam rigs compared to lenses with hard stops
  • Zeiss ZE lenses with hard stops are preferred over Canon zooms because they respond to lens mapping features in Preston follow focus systems
  • Canon zooms require visual focus confirmation through HD transmission rather than traditional marking systems because their focus rings have no defined stops

Hängt ab von

  • Solutions discussed were specific to earlier Steadicam setups in 2010
  • Focus pulling difficulties mentioned relate specifically to Canon's electronic focusing system design
  • Some solutions were improvised for individual shoots rather than thoroughly tested designs

Geräte in dieser Diskussion

HU3

Bauteile

Follow Focus

Dieselben Geräte oder Bauteile

  1. 2026Wechseln eines ARRI ALEXA 35 zwischen Stativ/Studio und Steadicam® Montage: Grundplattenwahl und schnellster Workflow.FacebookSteadicam operators group
  2. 2026Fokussieren und Zoomen Sie sich während des Betriebs, insbesondere bei Live-ShowsOperator practice
  3. 2025LC-1 (Lens Control-1) Follow Focus-System: verdrahtete Architektur, Motoren und frühe Betriebserfahrung (1990er Jahre).FacebookThe Steadicam Group
  4. 2024Modifikationen an einem Steadicam Scout-Rig für erweiterte Stromverteilung und KonnektivitätGeneral Discussion
Originaldiskussion lesenFrage zu dieser DiskussionDie Antwort nennt ihre Quellen