Was die Diskussion ergab

• An Arri SR3 camera can be powered from a Clipper 324 sled's 24V Lemo connector without issues, even when voltage approaches the upper acceptable limit.
• Voltage from a Clipper 324 with two Steadicam cubes starts around 33.28V and drops to approximately 32.20V within the first minute of use, remaining within acceptable operating parameters.
• Using sled power instead of camera battery can reduce weight on the stabilizing arm, though the camera battery can alternatively serve as ballast for balance.
• Additional powered devices on the sled such as follow focus systems and video transmitters will draw additional current and further reduce voltage.

Hängt ab von

• The advice is based on experience with Clipper 324 and PowerCube batteries, not exhaustive testing across all conditions.
• This approach assumes familiarity with acceptable voltage ranges and camera protection mechanisms.

Bauteile

Follow Focus

Dieselben Geräte oder Bauteile

1. 2026Fokussieren und Zoomen Sie sich während des Betriebs, insbesondere bei Live-ShowsOperator practice
2. 2026Wechseln eines ARRI ALEXA 35 zwischen Stativ/Studio und Steadicam® Montage: Grundplattenwahl und schnellster Workflow.FacebookSteadicam operators group
3. 2025LC-1 (Lens Control-1) Follow Focus-System: verdrahtete Architektur, Motoren und frühe Betriebserfahrung (1990er Jahre).FacebookThe Steadicam Group
4. 2024Modifikationen an einem Steadicam Scout-Rig für erweiterte Stromverteilung und KonnektivitätGeneral Discussion