Was die Diskussion ergab

• The Seitz 8700 system uses a 9-pin D-connector with specific pin assignments for power, ground, camera run signals, and three channel signals.
• Pin 4 and Pin 7 both supply 12 volts DC, with Pin 4 for general power and Pin 7 specifically for powering the amplifier.
• Pin 3 provides ground connection using black 24 AWG wire.
• The receiver can be powered independently by providing 12 volts DC and ground through the appropriate pins of the 9-pin D-connector without requiring a Steadicam IIIA unit.
• A custom cable or adapter box matching the pinout of the original IIIA connector can be engineered to power and operate the 8700 receiver standalone.

Hängt ab von

• The technical manual for the Seitz 8700A was described as vague regarding connector specifications, using general descriptions rather than detailed pinouts.
• The Seitz company did not service these units after discontinuation and did not publish detailed customer-accessible documentation.
• The pinout for Lemo signal cables used in the system was not documented in available sources at the time of discussion.
• This discussion centers on 8700 and 8700A models from the early 2000s era.

Bauteile

Follow Focus

Dieselben Geräte oder Bauteile

1. 2026Wechseln eines ARRI ALEXA 35 zwischen Stativ/Studio und Steadicam® Montage: Grundplattenwahl und schnellster Workflow.FacebookSteadicam operators group
2. 2026Fokussieren und Zoomen Sie sich während des Betriebs, insbesondere bei Live-ShowsOperator practice
3. 2025LC-1 (Lens Control-1) Follow Focus-System: verdrahtete Architektur, Motoren und frühe Betriebserfahrung (1990er Jahre).FacebookThe Steadicam Group
4. 2024Modifikationen an einem Steadicam Scout-Rig für erweiterte Stromverteilung und KonnektivitätGeneral Discussion