2008Foro Cameras (Film/Video/HD)
Panavision F23 configuración de cámara para mano y Steadicam trabajo con configuración de grabación de dos piezas
Tiene 18 años. Es posible que el equipo y los precios hayan cambiado desde entonces.
Lo que encontró el hilo
- El F23 puede funcionar en modo de dos piezas sin problemas técnicos inherentes cuando la cámara y el grabador están en los modos de funcionamiento correctos
- Hasta 100 pies de cable coax estándar se puede utilizar para la grabación F23 de dos piezas
- Two-piece mode on F23 supports only fixed frame rates of 23.98, 24, 25, 29.97, 30, 50, and 59.97 fps; variable speed work requires one-piece operation
- Fiber optic conversion systems like the Telecast Rattler introduce approximately one frame of audio delay and require two transmitter-receiver pairs for dual-link operation
- The F23 power connector is mechanically similar to Genesis but exits the camera body at a different angle (22.5 degrees instead of side-mounted)
- To record over 30 fps in 4:4:4 chroma subsampling on the SRW-1 recorder, the HKSR103 board must be installed; over 30 fps without this board is limited to 4:2:2
- Back-mounted batteries work for handheld two-piece operation; Steadicam sleds can power the F23 via Y-connector cables
Depende de
- Reports about F23 versus Genesis power cable compatibility were conflicting in the source community
- Fiber optic systems were cost-prohibitive for this production at around 800 dollars per day
- The HKSR103 board for high frame rate 4:4:4 recording was rare and expensive
- Audio delay from fiber systems requires sound department awareness and potential delay compensation equipment