SteadiHub
2010Foro Brackets/Widgets

Pro2 Landing Pad 2.0 modificaciones para reducción de peso y posicionamiento de baterías versátil

Tiene 16 años. Es posible que el equipo y los precios hayan cambiado desde entonces.

Lo que encontró el hilo

  • The revised landing pad design uses interchangeable mounting plates with standard tapped holes, allowing users to attach different plate configurations to the base unit.
  • The landing pad with a 7-inch pro plate weighs just under one pound, while the base unit alone weighs approximately 0.5 pounds.
  • The landing pad provides a stable, flat surface for setting down the sled without placing weight directly on battery connectors.
  • The modular foot design enables battery repositioning strategies such as moving the front battery lower for top-heavy camera rigs or forward for monitor placement.
  • Mounting a battery on a dovetail plate via an aluminum bracket can help distribute weight and modify the rig's center of gravity for different camera configurations.
  • Heavier camera packages benefit more from the landing pad's weight distribution capabilities than lighter setups under 30 pounds.
  • Image flipping in post-production can sometimes replace low-mode wedges and related mounting hardware, potentially saving weight and setup time.

Depende de

  • This discussion focuses on a specific prototype and production design from a single manufacturer around 2010.
  • The battery positioning examples provided were experimental setups and not necessarily recommended for standard use.
  • Weight savings calculations are specific to particular battery types and accessory combinations mentioned in the thread.
  • Some users expressed caution about setting rigs down on battery connectors despite the stated design intention.
  • The homebrew dovetail bracket solution described was a temporary prototype, not a finished product design.

Piezas

Dovetail Plate, Low Mode

Mismo equipo o piezas

  1. 2026Chaleco gotas: lo que baja la toma del brazo realmente compra, y lo que cuesta en la parte superiorOperator practice
  2. 2026Eliminar la vibración con el ARRI ALEXA 35 en Steadicam®: opciones de montaje rígido para pasar el sistema dovetailFacebookThe Steadicam Group
  3. 2026Conectores Lemo en el ARRI Artemis sled: pinout, verificación de polaridad y potenciación de low-mode monitores y batería Volt.FacebookSteadicam operators group
  4. 2026Cambie la cámara entre trípode y plataforma: la actualización más barata que la mayoría de los operadores nunca hacenOperator practice
Leer el hilo originalPregunta sobre este hiloLa respuesta cita el archivo