2012Forum Center Post
Dépannage d'un poteau central rigide ou difficile à abattre sur des grues professionnelles
Il y a 14 ans. Le matériel et les prix ont peut-être changé depuis.
Ce que le fil a révélé
- La torsion de la section inférieure de sled dans des directions opposées par rapport à la section supérieure peut aider à réduire la friction lorsqu'un poteau central est difficile à écrouler.
- Détachement du junction box et torsion du câble de poste peut soulager la liaison entre le câble et le post intérieur.
- Rotating the lower mount clockwise while the bottom sled is detached tightens the cable coil diameter and reduces friction with the post walls, but this reduces maximum extension length and increases cable strain.
- Over-tightening during previous use can cause rubbing between outer and inner post sections and make collapsing difficult.
- Worn or damaged inner post sections may require replacement to restore smooth operation.
- Talcum powder applied to the post walls can reduce friction.
- Silicone lubricant applied to the interior walls may help reduce friction, though this approach is not officially recommended by the manufacturer.
- Ensuring low-mode dock rings are not overtightened can prevent collapsing problems.
Dépend de
- The quoted manual tip could not be located in currently available manuals, suggesting it may be from older documentation or misremembered.
- The lubricant approach is acknowledged as potentially unsanctioned by the manufacturer.
- The cable-twisting technique involves a tradeoff: reduced friction comes at the cost of reduced extension range and increased cable strain.
- Experience reports vary by post generation, with Gen 1 posts reportedly having different tolerances than Gen 2 HD posts.
- The exact tolerances between inner and outer post sections are noted as very tight, making most modifications risky.
Pièces
Même matériel ou mêmes pièces
- 2026Gilet gouttes: ce qui abaisse la prise de bras achète réellement, et ce que cela coûte en hautOperator practice
- 2026Connecteurs Lemo sur le ARRI Artemis sled : pignon, vérification de la polarité et alimentation low-mode moniteurs et batterie Volt.FacebookSteadicam operators group
- 2026Montage du cerveau TIFFEN Volt : comparaison de rigidité entre les supports ARRI et CamJam pour minimiser les vibrationsControverséSteadiHub
- 2026Low mode et retourner l'image: quoi vérifier sur la caméra avant la journéeOperator practice