2009Forum Steadi-Newbies
Équilibrer un Steadicam Pilot avec une caméra XH-A1
Il y a 17 ans. Le matériel et les prix ont peut-être changé depuis.
Ce que le fil a révélé
- Une configuration de départ recommandée pour le Pilot avec XH-A1 implique environ huit livres en haut et deux livres en bas avec la batterie.
- D'autres poids moyens d'un quart de livre peuvent être ajoutés pour atteindre un bon équilibre, avec des configurations typiques utilisant deux poids moyens de chaque côté du fond.
- Dynamic balance on a Pilot rig is best achieved by positioning the camera center of gravity slightly behind the post's center line because the monitor sits high and away from the post while the battery hangs lower and is heavier.
- One effective balancing procedure involves marking the camera's center of gravity, mounting it at a fixed distance behind the post center line, then adjusting the battery position while keeping the top stage fixed to achieve dynamic balance.
- The rig's dynamic balance changes when the center post length is extended, so post length should remain consistent when setting up a rig configuration.
- To verify dynamic balance, spin the rig and observe which direction it precesses; if it tips toward the nose, move the lower spar back and slide the camera forward; if it tips back, do the reverse.
- Raising or lowering the gimbal does not change dynamic balance.
- On rigs where the monitor is positioned high and far from the post with the battery below, the camera center of gravity must be behind the post for dynamic balance to be achievable.
Dépend de
- These weight recommendations and procedures are described as working for the Pilot with IDX batteries specifically.
- The optimal balancing approach may vary depending on monitor and battery placement relative to the post.
- Specific accessory configurations or different cameras may require re-balancing the rig.
- The described methods rely on experimental adjustment rather than manufacturer specifications.
Pièces
Même matériel ou mêmes pièces
- 2026Mise à niveau d'un ancien Steadicam® MK-V avec 1,5 pouce de poste à Volt configuration ou passage au nouveau Steadicam® Elite (1,25 pouce de poste, 14 kg).FacebookThe Steadicam Group
- 2026Priorités de mise à niveau recommandées pour un appareil GPI Pro steadicamSteadi-Newbies
- 2026Échanger la caméra entre trépied et plate-forme: la mise à niveau la moins chère la plupart des opérateurs ne font jamaisOperator practice
- 2026Transvideo a cessé le commerce: ce que les propriétaires de leurs moniteurs doivent savoirOperator practice