What the thread found

• The D-sub connector on the bottom of the EFP was designed to connect to follow focus receiver systems like Seitz or WC 4 units via motorcable lemos connectors running up the post.
• The connector can be repurposed to carry power, video, and other signals like tally light feeds to external devices such as program monitors.
• Dynamic balancing of an EFP sled is possible through modifications including repositioning the battery bracket rearward using spacers, replacing the upper junction box, and adding secondary battery mounts.
• The pin configuration of the base connector has been documented in CP manuals for the Steadicam 3 junction box wiring.

Depends on

• No detailed pin assignments were provided in this thread discussion.
• The specific wiring diagram details mentioned were referenced but not included in the thread text.
• Modifications described were performed on individual rigs and results may vary depending on setup and implementation.

Parts

Monitor Bracket, Follow Focus

Same gear or parts

1. 2026Modernizing Steadicam® PRO sled: Gen-2 battery holder retrofit and universal monitor bracket on the tube collar.FacebookSteadicam operators group
2. 2026Pulling focus and zoom yourself while operating, especially on live showsOperator practice
3. 2026Low mode and flipping the image: what to check on the camera before the dayOperator practice
4. 2026Powering everything from the sled: voltage, current, and why the two get confusedOperator practice