2015Video Assist and Video Accessories forum
Teradek Bolt 300 Rx receiver loses signal and stops responding
What the thread found
- A receiver that was functioning normally can suddenly stop accepting signals from the transmitter, with the only indication being a blinking blue LED at the power switch and no other lights activating.
- Swapping out the power cable can temporarily restore functionality, but the problem may recur within hours.
- Internal solder joint failures or loose wiring inside the receiver can cause signal loss and unresponsive behavior.
Depends on
- The issue was not fully resolved in the thread; the user planned to attempt firmware reinstall but did not report back on the outcome.
- The temporary fix of changing power cables suggests a power delivery issue, but the underlying cause was not conclusively determined.
- Only one unit's failure is documented here.