SteadiHub
2008Arms forum

Compatibility of Clipper 324 stabilizer with G-70 arm instead of standard G-50 arm

18 years old. Gear and prices may have changed since.

DisputedParticipants disagreed and reached no conclusion. Read the findings as positions, not as an answer.

What the thread found

  • The manufacturer does not sell the Clipper 324 with a G-70 arm as a factory combination.
  • The Clipper 324 top stage is rated for a maximum payload of 30-35 pounds, which limits the types of camera systems that can be mounted.
  • The Clipper 324 uses the same post design as the U2 model, so structural post failure is unlikely even with heavier loads.
  • The primary concern with mounting very heavy cameras on a Clipper 324 is potential vibration issues rather than structural failure, particularly in low mode during dynamic movements, due to the smaller stage footprint and bearing design compared to the U2.
  • The Clipper 324 sled weighs approximately 11.3 to 15 pounds depending on battery configuration, compared to 17 pounds 13 ounces for the U2 sled without batteries.
  • Individual components including the sled, arm, and vest may be purchased separately from various manufacturers, potentially allowing custom combinations, though this may cost more than factory configurations.

Depends on

  • The manufacturer's official warranty may not cover damage from using non-approved configurations.
  • The 30-35 pound payload rating of the Clipper 324 may be insufficient for certain professional camera packages such as RED or 16mm cinema cameras with full accessories.
  • Claims about vibration issues are based on design analysis rather than extensive testing data.
  • The discussion mentions one person's experience standing on a prototype stage but this is anecdotal evidence about bearing capacity.
  • Specific weight specifications for the Clipper 324 were calculated indirectly rather than from official published data.

Gear in this thread

G-70catalog

Parts

Top Stage, Low Mode

Same gear or parts

  1. 2026Upgrading an older Steadicam® MK-V with 1.5-inch post to Volt configuration or switching to the new Steadicam® Elite (1.25-inch post, 14 kg).FacebookThe Steadicam Group
  2. 2026Swapping the camera between tripod and rig: the cheapest upgrade most operators never makeOperator practice
  3. 2026Vest drops: what lowering the arm socket actually buys, and what it costs at the topOperator practice
  4. 2026Low-mode monitor selection for Volt Brain rig: latency performance of Transvideo Starlite versus current alternatives.DisputedFacebookThe Steadicam Group
Read the original threadAsk about this threadThe answer cites the archive