What the thread found

• A silver Sharpie marker can be used to mark carbon fiber posts, though the marks will wear away with regular use and require frequent reapplication.
• Paint pens or marker ink on carbon fiber are temporary solutions that will gradually smear and fade during use.
• Etching or scratching carbon fiber creates stress risers that can cause catastrophic failure of the material and should never be attempted.
• Manufacturers avoid marking carbon fiber posts because engraving destroys structural carbon filaments, laser marking still cuts fibers, and silk-screening solutions are expensive and prone to errors.
• Modern carbon fiber post designs are more resistant to surface damage than earlier versions due to improved fiber weaving techniques.

Depends on

• The silver Sharpie solution is confirmed as temporary and requires repeated reapplication.
• The specific reasons manufacturers do not include end-of-travel marks on their products are based on manufacturing complexity rather than oversight.
• Carbon fiber posts with poor construction quality may be more susceptible to damage from marking attempts.
• The exact availability and specifications of silver Sharpie markers vary by region.

Gear in this thread

Master Seriescatalog

Same gear or parts

1. 2026Choosing between upgrading an older ProVid-2 kit or investing in a professional rig: workshop-first versus equipment-first approach for beginners.DisputedFacebookSteadicam operators group
2. 2026Entry-level stabilizer strategy on a 15,000 USD budget: Rever EVO versus used Artemis 2 or M2 plus Volt, in a market with limited secondhand availability.DisputedFacebookThe Steadicam Group
3. 2026Proper clamping force on gimbal saddle clamps with heavy cameras: risk of over-tighteningFacebookSteadicam operators group
4. 2026Adjusting play in a Steadicam® Master Series gimbal yoke and balancing it for smooth 180-degree pan without tipping.DisputedFacebookSteadicam operators group