What the thread found

• The camera uses a standard 4-pin 12V power connector for external power sources
• Start/stop control typically operates through a 2-pin Lemo hermaphrodite connector
• An 8-pin Lemo start/stop option is available as an alternative when ordering from certain equipment suppliers
• During extended continuous takes with a full 800-foot magazine, the weight distribution shifts significantly as film transfers from the feed side to the takeup side of the coaxial magazine
• A motorized top stage helps manage the weight shift during long continuous takes
• The camera is considered reliable for multi-camera setups and extended recording sessions

Depends on

• Power and connector specifications may vary depending on the rental source or specific camera configuration
• Weight shift management becomes critical only during very long continuous takes with full 800-foot magazines
• Some connector compatibility issues can occur between different control systems that use similar Lemo configurations

Gear in this thread

MDR

Parts

Top Stage

Same gear or parts

1. 2026Power loss on Trinity 2 / Artemis 2 with large cameras (A35, Venice): causes and battery solutions.DisputedFacebookArri Artemis Trinity
2. 2026Choosing between upgrading an older ProVid-2 kit or investing in a professional rig: workshop-first versus equipment-first approach for beginners.DisputedFacebookSteadicam operators group
3. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rod mounts and CamJam mounts to minimize vibrationsDisputedSteadiHub
4. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest workflow.FacebookSteadicam operators group