What the thread found

• Play in the M1 gimbal is typically caused by a loosened upper bearing ring, which can be tightened without disassembling the gimbal.
• On Volt-equipped gimbals, an encoder/sensor ring sits at the top, adhered with tape; it must be carefully lifted—for example with a razor blade—without destroying the adhesive layer, then tightened using the matching spanner wrench.
• In one instance, tightening the ring from the top of the gimbal eliminated the play, after which verification in Low Mode was recommended.
• If the ring is not re-tightened, play returns.
• The gimbal manufacturer provides an instructional video and offers direct technical support for this procedure.

Gear in this thread

Voltcatalog

Parts

Low Mode

Same gear or parts

1. 2026Rig setup for 180-degree immersive camera operation with Blackmagic URSA Cine Immersive: minimizing rig and monitor visibility in ultra-wide field of view.FacebookThe Steadicam Group
2. 2026Operating a Steadicam® Zephyr without Volt: drop time, horizon control, and the effect of upper-rig weight distribution on balance.DisputedFacebookSteadicam operators group
3. 2026Why a 150 Wh battery at the sled powers the camera for only ~20 minutes versus two to three times longer when mounted on-body, and how to extend runtime.DisputedFacebookThe Steadicam Group
4. 2026Low-mode monitor selection for Volt Brain rig: latency performance of Transvideo Starlite versus current alternatives.DisputedFacebookThe Steadicam Group