2011Gimbal forum
Incompatibility issues between XCS Ergo handle and PRO gimbal components causing premature wear
15 years old. Gear and prices may have changed since.
What the thread found
- Combining a PRO yoke with an XCS Ergo handle spud can result in visible rubbing and wear on the conical connection within weeks of use
- The spindle connection between handle and gimbal is a critical tolerance that determines the stability of the entire rig
- Manufacturing tolerance variations between different manufacturers can exceed acceptable limits even when components are theoretically compatible
- Surface treatment differences such as anodizing thickness can create tolerance mismatches between supposedly compatible parts
- Mixing components from different manufacturers voids manufacturer support and creates no recourse if problems develop
Depends on
- The discussion does not confirm whether the rubbing leads to functional failure or only cosmetic damage
- No information provided about whether proper assembly procedure was followed in the original setup that failed
- The issue may have been partially related to initial mushrooming damage rather than inherent incompatibility
- Only one user reported this specific combination showing problems in this thread