Sign In Sign Up

Archive

6,286 forum threads from 2003 to 2026, condensed into what operators found out.

Camera510 Focus468 Mounts645 Gimbal473 Arm490 Sled596 Power465 Monitor1,008 Electronics422 Stand70

Not in the picture: Vest 369

Tap a part. Numbers count threads in the archive.

Frequently asked

How much weight can my rig safely carry before it fails?Rig failure · 64 threads

Will my camera fly on my Steadicam® or stabilizer?Camera · 62 threads

Which monitor is bright enough to see in direct sunlight?Monitors · 51 threads

Which entry-level rig should I buy as a beginner?Getting started · 47 threads

What day rate should I charge as a Steadicam® operator?Business and rates · 38 threads

What weight can this rig carry for my camera?Buying · 37 threads

Beyond the rig

Getting started532

Business and rates413

Gear

ZephyrCan I fly my Alexa or RED on a Zephyr?389

Master SeriesIs a used Master Series rig worth buying as a first big rig?191

BFDHow do I power my BFD receiver from my camera or sled?186

VoltCan I retrofit a Volt onto my existing sled or gimbal?168

ArtemisHow do I power my camera and accessories from an Artemis sled?166

MDRWhere can I mount my Preston MDR on my rig?143

ModulusIs there a Modulus option for HD wireless video?141

G-70Will my G-70 fit my vest, gimbal or sled?126

FI+ZCan I control iris and zoom wirelessly, not just focus?60

HU3Where can I get my HU3 repaired, refurbished or repainted?60

CineLiveHow do I pack and case my CineLive rig for transport?54

G-70XHow does the G-70X compare to Pro Titan, Xarm and other arms?46

Trinity 2Is Trinity 2 SUP 3.0 firmware safe to install or buggy?46

Ultra VestWhich vest should I choose for my body size, comfort and operator type?39

Still argued about All 959

By year

200320102026

2021Monitors forum

ACC connector pinout and video signal capability on Transvideo monitors

What the thread found

The 8-pin lemo monitor connector on the bottom of a sled typically carries power and analog video signals, not HD-SDI
Pin 3 of the ACC connector on a Transvideo monitor accepts analog video input (Y/CVBS)
To use a single cable for both power and video on a Transvideo monitor via the ACC connector, the signal source must output analog video rather than HD-SDI

Depends on

This applies to analog video workflows; HD-SDI requires a separate cable connection
The specific sled model mentioned was the RIG Betz, so applicability to other sled designs is unclear

Read the original thread Ask about this threadThe answer cites the archive