What the thread found

• A wedge that spins without tightening typically has damaged threads after extended use
• Wrapping paper tape on the camera dovetail can restrict wedge travel and restore temporary functionality
• If the wedge travels properly but fails to lock under heavy loads, increased manual tightening force may be needed, though care must be taken to avoid over-tightening
• Replacement parts may be available from the manufacturer
• A machinist can fabricate replacement wedge components

Depends on

• The temporary paper tape fix is not a permanent solution
• The heavy load scenario was not confirmed as the actual cause in this specific case
• Availability of replacement parts and machinist services varies by region

Parts

Top Stage

Same gear or parts

1. 2026Recommended upgrade priorities for a GPI Pro steadicam rigSteadi-Newbies
2. 2026Choosing between Wave, Volt 2, and MK-V Level gimbals: performance in wind, rig weight, maintenance, and mode switching.DisputedFacebookSteadicam operators group
3. 2026Mounting the TIFFEN Volt brain: rigidity comparison between ARRI rod mounts and CamJam mounts to minimize vibrationsDisputedSteadiHub
4. 2026Upgrading an older Steadicam® MK-V with 1.5-inch post to Volt configuration or switching to the new Steadicam® Elite (1.25-inch post, 14 kg).FacebookThe Steadicam Group