2010General Discussion forum
Lubricant choice for camera arm springs and joints
16 years old. Gear and prices may have changed since.
What the thread found
- ACF-50 is used by forum members for lubricating camera arm mechanisms, though it is primarily intended for extreme environmental conditions rather than routine maintenance
- Teflon-based lubricant applied in small quantities is an alternative recommendation for lubricating arm joints
- Applying lubricant once every one to two years can prevent squeaking and corrosion while maintaining bearing function
- Thorough cleaning to remove dust and grit should be done before relubrication, as accumulated particles are often the cause of creaking sounds
Depends on
- ACF-50 is described as unnecessary under normal conditions and better suited to extreme climates
- One participant acknowledged potential uncertainty about whether ACF-50 could damage rubber components
- The discussion does not provide detailed guidance on whether silicone grease is compatible with rubber seals on this equipment