What the thread found

• A 1.5 inch ring can be installed directly over the screw mounting area without causing damage to the screws or internal components.
• The ring should be positioned flush against the bottom of the top stage.
• Minor cosmetic marks on the anodized surface may occur but are acceptable and expected with this installation method.
• Over-tightening the ring should be avoided during installation.

Depends on

• The response was based on recollection rather than definitive documentation.
• Only cosmetic damage potential was addressed; long-term mechanical stress effects were not thoroughly analyzed.
• Specific equipment model and full technical specifications not provided in the discussion.

Parts

Top Stage

Same gear or parts

1. 2026Tiffen Steadicam® Elite sled (2026): build quality, power distribution, and load capacity versus Steadicam® Axis.FacebookSteadicam operators group
2. 2026Rig setup for 180-degree immersive camera operation with Blackmagic URSA Cine Immersive: minimizing rig and monitor visibility in ultra-wide field of view.FacebookThe Steadicam Group
3. 2026Reducing voltage drop in standard Steadicam® Zephyr cabling for high-power broadcast cameras.DisputedFacebookSteadicam operators group
4. 2026Swapping an ARRI ALEXA 35 between tripod/studio and Steadicam® mounting: baseplate choice and fastest workflow.FacebookSteadicam operators group