2008Steadi-Newbies forum
Balance adjustment procedure for dual-arm spring stabilizer rigs
18 years old. Gear and prices may have changed since.
What the thread found
- The two arm sections should move together as a unit, with both booming up or down simultaneously from center position and at both extremes of travel range.
- Imbalance between arm sections creates a bump in the middle of the boom travel, which degrades shot quality.
- Starting position depends on arm model: 3a and 3 spring type arms should begin slightly below horizontal, while MasterSeries, Flyer, Ultra, and G-series arms should start slightly above horizontal.
- The forearm section closest to the sled should be balanced first, then the upper section adjusted to track with it through the full range of motion.
- The specific shot requirements and working zone influence how the arm balance should be tuned for optimal performance.
- Operator posture and vest mounting affect arm behavior and should be considered when setting balance.
Depends on
- The discussion lacks specific information about PRO series arm starting position.
- Individual arm designs have different balance points and requirements.
- No precise numerical specifications are provided for balance adjustment.
- Workshop training is recommended but not substituted by online discussion.