What the thread found

• A custom bracket was developed to reposition the socket block on a PRO Vest, allowing lower boom positioning and better arm clearance compared to the stock configuration
• The modification eliminates elbow contact with the steadicam arm during boom movements and maintains similar operating feel to the original setup
• The bracket design uses multiple mounting holes to allow adjustment of the socket position without requiring an additional F-bracket
• Reversing the bracket angle for high-mode operation would require separate versions for standard and goofy-foot orientations due to socket facing direction
• Making the bracket work for goofy-foot operation requires only repositioning the lower strap and tapping new holes, though it involves sewing modifications to the vest

Depends on

• The modification voids the manufacturer warranty
• Design adds stress to the chest spar attachment area, with potential for future stress cracks
• The bracket cost approximately $775 plus shipping
• Only tested in standard operating mode, not validated for goofy-foot configuration
• Using only hole #2 of six available positions in the extension, so extreme adjustment scenarios untested

Gear in this thread

Master Seriescatalog

Parts

Low Mode

Same gear or parts

1. 2026Choosing between upgrading an older ProVid-2 kit or investing in a professional rig: workshop-first versus equipment-first approach for beginners.DisputedFacebookSteadicam operators group
2. 2026Entry-level stabilizer strategy on a 15,000 USD budget: Rever EVO versus used Artemis 2 or M2 plus Volt, in a market with limited secondhand availability.DisputedFacebookThe Steadicam Group
3. 2026Proper clamping force on gimbal saddle clamps with heavy cameras: risk of over-tighteningFacebookSteadicam operators group
4. 2026Adjusting play in a Steadicam® Master Series gimbal yoke and balancing it for smooth 180-degree pan without tipping.DisputedFacebookSteadicam operators group