2009Gimbal forum
Extending the grip length on a second-generation Flyer gimbal for better control
17 years old. Gear and prices may have changed since.
What the thread found
- A wrap-around grip extended from the original 3 inches to 5 inches can provide better hand positioning for proper pinky placement during tilts and pendular motion control.
- Delrin sleeves can be used for grip modifications, but small threads in thin Delrin sections risk stripping and helicoils are recommended for durability.
- The original Wrapgrip had approximately 1.5 inch inner diameter and 1.8 inch outer diameter, while later versions increased to 2 inch inner diameter.
- Grip diameter and length affect control through their distance from the center of gravity, but improved technique can compensate for minor diameter differences.
- A longer grip helps operators with smaller hands achieve a comfortable, relaxed grip position without overextending beyond the grip end.
- Delrin can be tapped with small diameter threads if loads remain light, but using taps that have never contacted metal produces better results.
Depends on
- The original Wrapgrip with 1.5 inch inner diameter is no longer commercially available from the manufacturer.
- The advice assumes a specific hand size and grip technique, making it less applicable to operators with different hand proportions.
- Claims about helicoil necessity versus direct tapping of Delrin were discussed but application-specific success depends on thread size, section thickness, and load conditions.
- The optimal balance between grip extension and control effectiveness remains subject to individual operator preference and technique development.