2025From SteadiHub members
Pairing an ARRI Trinity 1 head with a remote hand unit after previous pairing with different wheels.
Note (as of October 2026)Curt O. Schaller, the developer of Artemis and Trinity, has no longer been with ARRI since the end of 2025. To our knowledge, ARRI currently has no dedicated team and no official contact persons for its stabilizer systems. In our view, the future of this line is uncertain. If you are buying new, get written confirmation from ARRI beforehand on how long service and spare parts are guaranteed. Have used rigs checked by the manufacturer before you buy.
What the thread found
- The ARRI Trinity 1 head should emit a beeping signal after 5 seconds when entering pairing mode, as documented in the manual.
- When the head fails to pair with a remote control unit, the procedure is to press the remote pairing function while the remote is powered off.
- The remote control should be powered on when the pairing counter reaches 4 seconds, not at the start of the pairing sequence.
- This procedure applies when re-pairing a head that was previously paired with different wireless wheel units.
Depends on
- Procedure specific to ARRI Trinity 1.
- Applies to re-pairing scenarios after previous pairings with alternative wireless components.
Gear in this thread
Same gear or parts
- 2026Trinity vs. 360-degree roll head: practical job prospects and system flexibility for operator investment decisions.DisputedFacebookSteadicam operators group
- 2025Nodal point alignment of the Steadicam® T2 head with SAM plates and large-format cameras.SteadiHub
- 2025Mounting a monitor at the battery rack on ARRI Trinity 2 in AR/X-mode: holder options and balance considerations.FacebookArri Artemis Trinity
- 2025Market saturation of ARRI Trinity systems in 2025: demand collapse, rental rates, and ROI viability across regions.DisputedFacebookArri Artemis Trinity