Sign In Sign Up

Archive

6,286 forum threads from 2003 to 2026, condensed into what operators found out.

Camera510 Focus468 Mounts645 Gimbal473 Arm490 Sled596 Power465 Monitor1,008 Electronics422 Stand70

Not in the picture: Vest 369

Tap a part. Numbers count threads in the archive.

Frequently asked

How much weight can my rig safely carry before it fails?Rig failure · 64 threads

Will my camera fly on my Steadicam® or stabilizer?Camera · 62 threads

Which monitor is bright enough to see in direct sunlight?Monitors · 51 threads

Which entry-level rig should I buy as a beginner?Getting started · 47 threads

What day rate should I charge as a Steadicam® operator?Business and rates · 38 threads

What weight can this rig carry for my camera?Buying · 37 threads

Beyond the rig

Getting started532

Business and rates413

Gear

ZephyrCan I fly my Alexa or RED on a Zephyr?389

Master SeriesIs a used Master Series rig worth buying as a first big rig?191

BFDHow do I power my BFD receiver from my camera or sled?186

VoltCan I retrofit a Volt onto my existing sled or gimbal?168

ArtemisHow do I power my camera and accessories from an Artemis sled?166

MDRWhere can I mount my Preston MDR on my rig?143

ModulusIs there a Modulus option for HD wireless video?141

G-70Will my G-70 fit my vest, gimbal or sled?126

FI+ZCan I control iris and zoom wirelessly, not just focus?60

HU3Where can I get my HU3 repaired, refurbished or repainted?60

CineLiveHow do I pack and case my CineLive rig for transport?54

G-70XHow does the G-70X compare to Pro Titan, Xarm and other arms?46

Trinity 2Is Trinity 2 SUP 3.0 firmware safe to install or buggy?46

Ultra VestWhich vest should I choose for my body size, comfort and operator type?39

Still argued about All 959

By year

200320102026

2020General Discussion forum

Tally signal voltage compatibility between Clipper3 and Tvlogic F-7h mk2 monitor

What the thread found

The TALLY SENSE pin on the 8-pin Lemo connector of Clipper3 outputs an unregulated 12V signal with a typical range of 11V to 16V.
Tvlogic F-7h mk2 monitor requires a 5V tally input signal with a tolerance of plus or minus 2 volts.
A voltage transducer must be installed in the tally cable to step down the 12V output from Clipper3 to the 5V input required by the Tvlogic monitor.

Depends on

The voltage specification for Clipper3 was not confirmed by direct equipment testing but based on user recollection.
No specific transducer model or wiring diagram was provided in the discussion.

Read the original thread Ask about this threadThe answer cites the archive